Orange kitten cottage Paper Squishy

What you'll need

• 80–100 gsm paper, scissors, clear tape and a little soft filling. Print one size at 100%. Copy part letters to the back before cutting.

Assembly overview

1. 80–100 gsm paper, scissors, clear tape and a little soft filling. Print one size at 100%. Copy part letters to the back before cutting. Measure the 50 mm line before cutting. Use either the color or coloring sheets, not both. Cut solid outlines. Fold dashed lines only. Optional: cover the printed side with clear tape before cutting. Edges meet; do not overlap. Bridge each seam with clear tape on the outside. Use short pieces around curves and corners.
2. Cut A, R and K. The doorway is printed artwork: do not cut it out. K is a standing paper decoration. Fold only the dashed lines; keep both gables in the wall planes.
3. Fold the four walls of A into a rectangular ring. Match the free wall edges at the free corner and tape outside. Keep the attached floor hanging open.
4. Swing the floor up and tape its three free edges from below. Fold R along its center ridge and test it on both gables, then lift it off again. Do not glue the roof yet.
5. Add loose filling through the open roof. Keep both gables and all wall rims clear. Do not overfill; R must rest on the gables without pressure.
6. Place R over the two gables. Match the ridge and both eaves. Tape both eaves and all four sloping gable edges from outside. The roof has no hidden tabs.
7. Fold the 6 mm foot of K forward. Stand K against the printed door. Bridge each side edge of K to the house front with a short piece of clear tape on the outside, as highlighted. The foot rests on the table; do not tape it to the table. K stays flat and unfilled.