Home / Templates / Squishies for Sale desk sign

Printable

Squishies for Sale desk sign

A single fold-out sheet makes a two-sided triangular counter sign. Untested trial edition. Assembly and squeeze recovery have not been physically tested.

Squishies for Sale desk sign preview
Download

Get the template pack

Choose one set: colour or colouring. Print single-sided at 100% and measure the 50 mm bar. Use printer paper, clear tape, loose tissue, scissors and a ruler. Colour first. Tape the printed faces lightly; leave fold lines free. Copy letters onto the blank backs, then cut only the solid outer edges.

Choose your paper size

Template and guide
English

Individual file downloads
Difficulty: Medium Theme: Everyday Paper: A4 / US Letter File: PDF / WebP / ZIP Print scale: 100% 3D template
Printable templates

Assembly guide

Illustrations show the intended finished shape.

What you'll need

  • Choose one set: colour or colouring. Print single-sided at 100% and measure the 50 mm bar. Use printer paper, clear tape, loose tissue, scissors and a ruler. Colour first. Tape the printed faces lightly; leave fold lines free. Copy letters onto the blank backs, then cut only the solid outer edges.
Assembly notes

Color template 1/1

Choose one set: colour or colouring. Print single-sided at 100% and measure the 50 mm bar. Use printer paper, clear tape, loose tissue, scissors and a ruler. Colour first. Tape the printed faces lightly; leave fold lines free. Copy letters onto the blank backs, then cut only the solid outer edges.

Assembly notes

Coloring template 1/1

Choose one set: colour or colouring. Print single-sided at 100% and measure the 50 mm bar. Use printer paper, clear tape, loose tissue, scissors and a ruler. Colour first. Tape the printed faces lightly; leave fold lines free. Copy letters onto the blank backs, then cut only the solid outer edges.

Assembly overview

  1. Cut out the entire net in one piece. Keep both triangular caps attached to base B. Crease the dashed lines. Turn the sheet blank-side up with B flat. Raise F, then bend R back over the ridge.
  2. Bring R's free 110 mm edge to the free long edge of B. Leave both ends open, lift the sign slightly and support the seam from inside. Press half the tape onto the outer back and half onto the underside.
  3. Fold the far cap up and tape both sloping edges. Lightly fill through the near end. Move tissue away from the rim. Raise the near cap 90° about its bottom hinge until its tip meets the ridge.
  4. Seal seam 1 to F first. At seam 2 stick half the tape on the cap, then fold the free half onto R. Press both seams from base corners to ridge. Set the sign on a flat table and check it stands after a gentle press.

Image preview