Home / Templates / Opening grey and red paper microwave

Printable

Opening grey and red paper microwave

Opening grey and red paper microwave. Digital paper-craft trial. Hinge life, tape adhesion and physical assembly remain untested. Images are assembly illustrations.

Opening grey and red paper microwave preview
Download

Get the template pack

Choose ONE template: colour or colour-in. Print at 100% and measure the 50 mm bar.

Choose your paper size

Template and guide
English

Individual file downloads
Difficulty: Medium Theme: Everyday Paper: A4 / US Letter File: PDF / WebP / ZIP Print scale: 100% 3D template
Printable templates

Assembly guide

Illustrations show the intended finished shape.

What you'll need

  • Paper, scissors, ruler and clear tape.
Assembly notes

Assembly guide 1/5

Open the door to see the tray. Then close it gently against S. Check that P stays still and D clears the roof and floor. If it catches, lift the hinge strips and recenter the door before pressing them down.

Assembly notes

Assembly guide 2/5

Open the door to see the tray. Then close it gently against S. Check that P stays still and D clears the roof and floor. If it catches, lift the hinge strips and recenter the door before pressing them down.

Assembly notes

Assembly guide 3/5

Open the door to see the tray. Then close it gently against S. Check that P stays still and D clears the roof and floor. If it catches, lift the hinge strips and recenter the door before pressing them down.

Assembly notes

Assembly guide 4/5

Open the door to see the tray. Then close it gently against S. Check that P stays still and D clears the roof and floor. If it catches, lift the hinge strips and recenter the door before pressing them down.

Assembly notes

Assembly guide 5/5

Open the door to see the tray. Then close it gently against S. Check that P stays still and D clears the roof and floor. If it catches, lift the hinge strips and recenter the door before pressing them down.

Assembly overview

  1. Cut only the outer cross of N. Fold the four inner edges; keep S flat. Crease the four dashed lines around the centre of N against a ruler. Raise all four flaps toward the white back until each makes a right angle. Grey surfaces face out.
  2. Butt each side wall against the roof and floor. Support from inside and fold short overlapping strips over the four outside corner seams, from the back to the open front.
  3. Fold I to a right angle so the two printed faces look into the cavity. Slide it into N with the vented section against the back and the round tray on the floor.
  4. Press I into the rear bottom corner. Tape its upper edge to the back wall and its front edge to the floor. Keep the left front edge clear for the hinge.
  5. Lay P face down. Centre S behind the edge next to the door. Align S’s dotted line with that edge: 6 mm lie on P and 4 mm project into the doorway. Tape S to the back of P. Keep S flat.
  6. Place P on the right of the opening, controls upright and S behind it toward the centre. Tape the top, right and bottom edges of P to N. Leave the door opening clear.
  7. Hold D over the opening with the window facing out and the handle beside P. Centre the door with about 1 mm clearance along all four edges. It rests against the projecting part of S.
  8. With D closed, bridge its left edge to the outer left wall with three short strips at the top, middle and bottom. Leave the small gap under the tape so it can bend. Swing the free handle edge toward you.
  9. Open the door to see the tray. Then close it gently against S. Check that P stays still and D clears the roof and floor. If it catches, lift the hinge strips and recenter the door before pressing them down.

Image preview