Mini yellow butter bar

Assembly overview

1. Choose one template and its paper size. Print at 100%, without Fit to Page. Check that the 50 mm bar measures 50 mm before cutting.
2. Cut only the solid outer outline, including the notches. Keep every face and tab connected. Do not cut dashed lines.
3. Pre-fold every dashed line with a ruler and blunt tool. A and C are wide faces; B and D are narrow. Mini caps: also pre-fold T1 and T2. Keep the artwork outside. Color a coloring sheet before assembly.
4. Wrap A-B-C-D into a tube. Slide J under the free long edge of A, up to the dashed line. The overlap is 6 mm. Hold from inside and tape the outside seam.
5. At end 1, fold B1 and D1 inward. Pre-fold T1; close cap A1, sliding T1 underneath face C. Tape the three free perimeter edges of A1. Leave end 2 open for filling.
6. Push small loose pieces of tissue or fiberfill through open end 2. Fill lightly and keep the end-flap area clear. Do not pack the body hard.
7. At end 2, fold B2 and D2 inward. Pre-fold T2; close cap A2, sliding T2 underneath face C. Tape the three free perimeter edges of A2.
8. Smooth the corners and press the center lightly. If the paper feels too tight or a seam pulls, reopen end 2, remove some filling and reseal. Do not force the paper flat.